[v2] net/e1000: fix buffer overrun while i219 processing DMA transactions
Checks
Commit Message
Intel® 100/200 Series Chipset platforms reduced the round-trip
latency for the LAN Controller DMA accesses, causing in some high
performance cases a buffer overrun while the I219 LAN Connected
Device is processing the DMA transactions. I219LM and I219V devices
can fall into unrecovered Tx hang under very stressfully UDP traffic
and multiple reconnection of Ethernet cable. This Tx hang of the LAN
Controller is only recovered if the system is rebooted. Slightly slow
down DMA access by reducing the number of outstanding requests.
This workaround could have an impact on TCP traffic performance
on the platform. Disabling TSO eliminates performance loss for TCP
traffic without a noticeable impact on CPU performance.
Please, refer to I218/I219 specification update:
https://www.intel.com/content/www/us/en/embedded/products/networking/
ethernet-connection-i218-family-documentation.html
Cc: stable@dpdk.org
Signed-off-by: Xiao Zhang <xiao.zhang@intel.com>
---
v2
Change the fix from igb_rxtx to em_rxtx, since i219 use em PMD.
v1
Apply kernel fix to igb PMD driver.
---
drivers/net/e1000/base/e1000_ich8lan.h | 1 +
drivers/net/e1000/em_rxtx.c | 16 ++++++++++++++++
2 files changed, 17 insertions(+)
Comments
> -----Original Message-----
> From: Zhang, Xiao
> Sent: Sunday, July 21, 2019 1:02 AM
> To: dev@dpdk.org
> Cc: Lu, Wenzhuo <wenzhuo.lu@intel.com>; Zhao1, Wei
> <wei.zhao1@intel.com>; Zhang, Qi Z <qi.z.zhang@intel.com>; Zhang, Xiao
> <xiao.zhang@intel.com>; stable@dpdk.org
> Subject: [v2] net/e1000: fix buffer overrun while i219 processing DMA
> transactions
>
> Intel® 100/200 Series Chipset platforms reduced the round-trip latency for the
> LAN Controller DMA accesses, causing in some high performance cases a buffer
> overrun while the I219 LAN Connected Device is processing the DMA
> transactions. I219LM and I219V devices can fall into unrecovered Tx hang
> under very stressfully UDP traffic and multiple reconnection of Ethernet cable.
> This Tx hang of the LAN Controller is only recovered if the system is rebooted.
> Slightly slow down DMA access by reducing the number of outstanding
> requests.
> This workaround could have an impact on TCP traffic performance on the
> platform. Disabling TSO eliminates performance loss for TCP traffic without a
> noticeable impact on CPU performance.
>
> Please, refer to I218/I219 specification update:
> https://www.intel.com/content/www/us/en/embedded/products/networking
> /
> ethernet-connection-i218-family-documentation.html
>
> Cc: stable@dpdk.org
>
> Signed-off-by: Xiao Zhang <xiao.zhang@intel.com>
Acked-by: Qi Zhang <qi.z.zhang@intel.com>
Applied to dpdk-next-net-intel and v1 is reverted.
Thanks
Qi
@@ -133,6 +133,7 @@ POSSIBILITY OF SUCH DAMAGE.
#define E1000_FLASH_BASE_ADDR 0xE000 /*offset of NVM access regs*/
#define E1000_CTRL_EXT_NVMVS 0x3 /*NVM valid sector */
#define E1000_TARC0_CB_MULTIQ_3_REQ (1 << 28 | 1 << 29)
+#define E1000_TARC0_CB_MULTIQ_2_REQ (1 << 29)
#define PCIE_ICH8_SNOOP_ALL PCIE_NO_SNOOP_ALL
#define E1000_ICH_RAR_ENTRIES 7
@@ -1970,6 +1970,22 @@ eth_em_tx_init(struct rte_eth_dev *dev)
tctl |= (E1000_TCTL_PSP | E1000_TCTL_RTLC | E1000_TCTL_EN |
(E1000_COLLISION_THRESHOLD << E1000_CT_SHIFT));
+ /* SPT and CNP Si errata workaround to avoid data corruption */
+ if (hw->mac.type == e1000_pch_spt) {
+ uint32_t reg_val;
+ reg_val = E1000_READ_REG(hw, E1000_IOSFPC);
+ reg_val |= E1000_RCTL_RDMTS_HEX;
+ E1000_WRITE_REG(hw, E1000_IOSFPC, reg_val);
+
+ /* Dropping the number of outstanding requests from
+ * 3 to 2 in order to avoid a buffer overrun.
+ */
+ reg_val = E1000_READ_REG(hw, E1000_TARC(0));
+ reg_val &= ~E1000_TARC0_CB_MULTIQ_3_REQ;
+ reg_val |= E1000_TARC0_CB_MULTIQ_2_REQ;
+ E1000_WRITE_REG(hw, E1000_TARC(0), reg_val);
+ }
+
/* This write will effectively turn on the transmit unit. */
E1000_WRITE_REG(hw, E1000_TCTL, tctl);
}