[dpdk-dev,v4,1/7] e1000: enable device rx queue interrupt
Commit Message
Enable rx queue interrupt support on e1000 physical and emulated device.
Signed-off-by: Marvin Liu <yong.liu@intel.com>
@@ -23,6 +23,7 @@ New Features
* **Added vhost-user multiple queue support.**
+* **Support interrupt mode on e1000.**
Resolved Issues
---------------
@@ -81,6 +81,7 @@ static int eth_em_flow_ctrl_get(struct rte_eth_dev *dev,
static int eth_em_flow_ctrl_set(struct rte_eth_dev *dev,
struct rte_eth_fc_conf *fc_conf);
static int eth_em_interrupt_setup(struct rte_eth_dev *dev);
+static int eth_em_rxq_interrupt_setup(struct rte_eth_dev *dev);
static int eth_em_interrupt_get_status(struct rte_eth_dev *dev);
static int eth_em_interrupt_action(struct rte_eth_dev *dev);
static void eth_em_interrupt_handler(struct rte_intr_handle *handle,
@@ -107,6 +108,7 @@ static void em_vlan_hw_strip_disable(struct rte_eth_dev *dev);
static void eth_em_vlan_filter_set(struct rte_eth_dev *dev,
uint16_t vlan_id, int on);
*/
+static void em_rxq_intr_enable(struct e1000_hw *hw);
static int eth_em_led_on(struct rte_eth_dev *dev);
static int eth_em_led_off(struct rte_eth_dev *dev);
@@ -608,6 +610,9 @@ eth_em_start(struct rte_eth_dev *dev)
return ret;
}
}
+ /* check if rxq interrupt is enabled */
+ if (dev->data->dev_conf.intr_conf.rxq != 0)
+ eth_em_rxq_interrupt_setup(dev);
adapter->stopped = 0;
@@ -1277,6 +1282,42 @@ eth_em_interrupt_setup(struct rte_eth_dev *dev)
}
/*
+ * It clears the interrupt causes and enables the interrupt.
+ * It will be called once only during nic initialized.
+ *
+ * @param dev
+ * Pointer to struct rte_eth_dev.
+ *
+ * @return
+ * - On success, zero.
+ * - On failure, a negative value.
+ */
+static int
+eth_em_rxq_interrupt_setup(struct rte_eth_dev *dev)
+{
+ struct e1000_hw *hw =
+ E1000_DEV_PRIVATE_TO_HW(dev->data->dev_private);
+
+ E1000_READ_REG(hw, E1000_ICR);
+ em_rxq_intr_enable(hw);
+ return 0;
+}
+
+/*
+ * It enable receive packet interrupt.
+ * @param hw
+ * Pointer to struct e1000_hw
+ *
+ * @return
+ */
+static void
+em_rxq_intr_enable(struct e1000_hw *hw)
+{
+ E1000_WRITE_REG(hw, E1000_IMS, E1000_IMS_RXT0);
+ E1000_WRITE_FLUSH(hw);
+}
+
+/*
* It reads ICR and gets interrupt causes, check it and set a bit flag
* to update link status.
*