[3/4] net/bnxt: fix enabling autoneg on Whitney+
Checks
Commit Message
From: Kalesh AP <kalesh-anakkur.purayil@broadcom.com>
Driver should enable autoneg on a port if FW supports it.
Because of a wrong check, driver is not enabling autoneg
on a port after setting forced speed on Whitney+.
Fixes: 7bc8e9a227cc ("net/bnxt: support async link notification")
Cc: stable@dpdk.org
Signed-off-by: Kalesh AP <kalesh-anakkur.purayil@broadcom.com>
Reviewed-by: Somnath Kotur <somnath.kotur@broadcom.com>
Reviewed-by: Ajit Khaparde <ajit.khaparde@broadcom.com>
---
drivers/net/bnxt/bnxt_hwrm.c | 18 +++++++++---------
1 file changed, 9 insertions(+), 9 deletions(-)
@@ -1489,6 +1489,7 @@ static int bnxt_hwrm_port_phy_qcfg(struct bnxt *bp,
link_info->support_speeds = rte_le_to_cpu_16(resp->support_speeds);
link_info->auto_link_speed = rte_le_to_cpu_16(resp->auto_link_speed);
+ link_info->auto_link_speed_mask = rte_le_to_cpu_16(resp->auto_link_speed_mask);
link_info->preemphasis = rte_le_to_cpu_32(resp->preemphasis);
link_info->force_link_speed = rte_le_to_cpu_16(resp->force_link_speed);
link_info->phy_ver[0] = resp->phy_maj;
@@ -1543,6 +1544,12 @@ int bnxt_hwrm_port_phy_qcaps(struct bnxt *bp)
HWRM_UNLOCK();
+ /* Older firmware does not have supported_auto_speeds, so assume
+ * that all supported speeds can be autonegotiated.
+ */
+ if (link_info->auto_link_speed_mask && !link_info->support_auto_speeds)
+ link_info->support_auto_speeds = link_info->support_speeds;
+
return 0;
}
@@ -3243,15 +3250,8 @@ int bnxt_set_hwrm_link_config(struct bnxt *bp, bool link_up)
speed = bnxt_parse_eth_link_speed(dev_conf->link_speeds,
bp->link_info->link_signal_mode);
link_req.phy_flags = HWRM_PORT_PHY_CFG_INPUT_FLAGS_RESET_PHY;
- /* Autoneg can be done only when the FW allows.
- * When user configures fixed speed of 40G and later changes to
- * any other speed, auto_link_speed/force_link_speed is still set
- * to 40G until link comes up at new speed.
- */
- if (autoneg == 1 &&
- !(!BNXT_CHIP_P5(bp) &&
- (bp->link_info->auto_link_speed ||
- bp->link_info->force_link_speed))) {
+ /* Autoneg can be done only when the FW allows. */
+ if (autoneg == 1 && bp->link_info->support_auto_speeds) {
link_req.phy_flags |=
HWRM_PORT_PHY_CFG_INPUT_FLAGS_RESTART_AUTONEG;
link_req.auto_link_speed_mask =