[V1,2/2] test_plans/dual_vlan: optimize dual_vlan test plan
Checks
Commit Message
Add diable/enable "extend off" "strip off" in test plan.
Signed-off-by: Weiyuan Li <weiyuanx.li@intel.com>
---
test_plans/dual_vlan_test_plan.rst | 19 +++++++++++++------
1 file changed, 13 insertions(+), 6 deletions(-)
@@ -44,6 +44,10 @@ Enable vlan filtering on port 0::
testpmd> vlan set filter on 0
+Disable extend on port 0::
+
+ testpmd> vlan set extend off 0
+
Check whether the mode is set successful::
testpmd> show port info 0
@@ -103,6 +107,11 @@ Configure the traffic generator to send VLAN packets with the Tag Identifier
Test Case: Add/Remove VLAN Tag Identifier pass VLAN filtering
=============================================================
+Disable VLAN packet extend and strip port ``0``::
+
+ testpmd> vlan set extend off 0
+ testpmd> vlan set strip off 0
+
Enable VLAN filtering on port ``0``::
testpmd> vlan set filter on 0
@@ -240,12 +249,12 @@ and send 1 packet on port ``A``. Verify that the packet can been received on por
``B`` without VLAN Tag Identifier.
-Test Case: Configure receive port outer VLAN TPID
+Test Case: Configure receive port inner VLAN TPID
=================================================
-Enable vlan header QinQ on port ``0`` firstly to support set TPID::
+Enable VLAN packet extend on port ``0``::
- testpmd> vlan set qinq on 0
+ testpmd> vlan set extend on 0
Check whether the mode is set successfully::
@@ -260,9 +269,7 @@ Check whether the mode is set successfully::
Allmulticast mode: disabled
Maximum number of MAC addresses: 127
VLAN offload:
- strip off
- filter off
- qinq(extend) on
+ strip off, filter off, extend on, qinq strip off
Set Tag Protocol ID ``0x1234`` on port ``0``.
Nic only support inner model, except Intel® Ethernet 700 Series::